Bus Compressor
– advanced analog stereo VCA compressor with PEAK/RMS detection
– all parameters are digitally controlled via front panel and/or DAW (with dedicated plugin)
– dry/wet MIX control for parallel compression
– sidechain high pass filter with hardware insert and preview function
– adjustable THD for harmonically rich sound
– on-board measurement of PEAK/RMS levels
– 100% analog audio signal path
– total recall and A/B comparison from your favourite DAW
– LED matrix display and six encoders with push-button action for ease of control
– USB connectivity with MAC/PC

Bettermeker Bus Compressor DEMO

Digital Section
The sound of the Compressor is of course based on the quality of its analog audio path. But all the control and user interactions are performed in the digital domain. This allows us to incorporate options and possibilities not found in any standard analog compressors:

- recall last unit state after reboot
- Instant reset of all parameters
- Rapid, precise and repeatable adjustments
- Precisely linked stereo operation with the ease of a single control
- DAW automation and recall of all available parameters

The digital section of the Bus Compressor is based around high speed, 32-bit micro-controller, with dedicated firmware programmed into its memory (with the possibility of updating the firmware via USB connection). It's responsible for controlling the VCA, the user interface, presets management, audio measurement, USB connectivity and other Bus Compressor functions.

The use of separate ground planes for analog and digital section results in perfect noise isolation between these two worlds. High quality switching power supply, designed by Bettermaker, was used to provide low noise, hum free power to all analog and digital components.

Front panel
The front panel of the Bus Compressor is build around eye-catching LED matrix display, that allows you to monitor almost all functions available on the device, as well as input/output levels and amount of gain reduction applied by the compressor.